Before you order.

No. It slides in from the top between two rails and comes to rest on a stop at the bottom, then the magnetic lid closes over it. Held on all four sides, it can't tip over.

You just lift it. It's held only by magnets set flush into the stand, with no clips or pegs. We leave them visible on purpose, and they never touch the card.

The Slab stand is cut for the PSA slab. If yours comes from another grader, tell us when you configure your stand (France's MTG Grade and PCA, the UK's ACE, or the American CGC, Beckett, SGC and TAG). SGC slabs are a little wider and taller, so they get their own slot. Other slabs differ slightly in size, so we check before printing, and if yours doesn't fit, we refund you before anything is printed. The Magnetic stand takes magnetic holders from 35 to 130 pt.

Allow 3 to 5 working days before dispatch, 7 at most: that's the time to print your order, check it and pack it. The parcel then takes 2 to 4 days, tracked. Shipping costs €4.90 and is free on orders over €45. We deliver to mainland France, Belgium, Luxembourg and Monaco.

A polymer, printed layer by layer in our workshop in France. Up close you'll see very fine lines on the surface. Those are the layers, and the process always leaves them. Like any plastic, the stand doesn't like heat: above 60 °C it can warp, so keep it off a car's parcel shelf in summer.

They all line up. Each side carries two magnets: bring two stands together and they lock edge to edge, with nothing to slot in. Only upright stands stack. To add a level, take the lid off the stand below and set the next one straight on top. The magnets in its base hold it, and it closes the one underneath. Only the top level keeps its lid. Tilted stands go side by side, never in levels. Their angle is for cards you look down at, on a desk or a low shelf.

Three or four levels, as long as the stack leans against something. An upright stand is only 2 cm deep, so a stack standing alone in the middle of a cabinet will topple at the first nudge, from two levels up. Against a wall or the back of a shelf it stays put, and the weight is no problem. For freestanding stacks we're working on a deeper base, and on a wall rail to go higher.

Not yet for individual customers. An engraved plate is in the works; sign up on the home page and we'll let you know when it's out. For shops, dealers and clubs it's already possible from 20 pieces: we print the series in your colours, with your logo in relief.

You have 14 days after delivery to change your mind, no reason needed. Email us at contact@slabrack.fr, we'll send you the return address, and we refund you within 14 days of getting the stand back. If a piece arrives damaged, send us a photo and we'll reprint it at our cost, or refund you if you prefer.

Online payment opens soon. Until then, put together your cart, single stands or showcases, and send it to us by message, on Instagram (@slab.rack) or by email. We'll reply with the lead time and how to pay, then start printing.